Replacement of screen on Lenovo IdeaPad Gaming 3 15IMH05 screen made by LaptopScreen.com

Click here to buy the screen for Lenovo IDEAPAD Gaming 3 15IMH05

Tools

For the replacement process we'll need the following tools: Heat Gun, Plastic picks

Shut down the laptop

To begin turn the laptop off by pressing and holding the power button

Remove the bezel

Start removing the bezel. Start from the left side then using both hands go around the
perimeter unsnapping the tabs underneath. Put the bezel aside

Separate the LCD screen

The LCD screen is glued to the plastic cover. We need a Heat Gun to soften the glue.
Warm up right and left sides of the top cover. Using plastic pick start gently separating
the LCD screen. Use the Heat Gun repeatedly on both sides to make sure the glue is soft.
Separate the LCD screen and place it on the keyboard

Disconnect the screen

Use a plastic pick to open the connector&amp;amp;amp;amp;amp;rsquo;s bracket. Disconnect the video cable.
Discard the old screen

Connect the new screen

Take the new LCD screen and place it on the keyboard. Reconnect the video connector.
Close the connector&amp;amp;amp;rsquo;s bracket. CAUTION! It is very important not to
force any connectors. As well you must not twist or slant the connector when plugging it in

Test the new screen

Now it is a good time to test the new screen. Lift the screen up and press the power button.
If start-up graphics appears we can finish the installation process

Install the new screen using adhesive strips

Your new display is likely to come with no adhesive. We offer standard double-sided
tape for such repairs on our site: lapptopscreen.com Peel off the old adhesive strips
from the back cover. Use alcohol and a piece of cloth to clean the back side of the new
LCD screen and the inner surface of the top cover. Apply the new strips of adhesive on
the back cover. Lift the screen up and using a fine microfibre cloth apply pressure to
the display along the edges to catch the adhesive

Replace the bezel

Remove the protective film. Using plastic pick pull back hinge cover to make room for
the bezel. Replace the bezel. Start from the bottom making sure that the bezel goes
behind the hinge cover. Then go around the perimeter snapping the tabs back in place.

Wipe the screen with alcohol and fine microfibre cloth, turn the laptop on and we are done!